Electrical Information - Emerson DFR29 Manuel De L'utilisateur

SAFETY PRECAUTIONS
Contact the authorised installer for installation of this unit.
If the air conditioner is knocked over during use, turn off the unit and unplug it from the
main power supply immediately. Visually inspect the unit to ensure there is no damage.
If you suspect the unit has been damaged, contact a technician or customer service for
assistance.
In a thunderstorm, the power must be cut off to avoid damage to the machine due to
lightning.
To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed
control device.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from
traffic area and where it will not be tripped over.
Do not open the unit during operation.
When the air filter is to be removed, do not touch the metal parts of the unit.
Hold the plug by the head of the power plug when taking it out.

Electrical Information

The manufactures nameplate is located on the rear panel of the unit and contains electrical
and other technical data specific to this unit.
Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding
is important. The power cord is equipped with a three-prong grounding plug for protection
against shock hazards.
Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend
to use is not adequately grounded or protected by a time delay fuse or circuit breaker (the fuse
or circuit breaker needed is determined by the maximum current of the unit. The maximum current
is indicated on the nameplate located on unit ) , have a qualified electrician install the proper
receptacle.
Ensure the receptacle is accessible after the unit installation.
Do not use extension cords or an adapter plugs with this unit. However, if it is necessary
to use an extension cord, use an approved Dehumidifier extension cord only (available at
most local hardware stores).
To avoid the possibility of personal injury, always disconnect the power supply to the unit,
before installing and/or servicing.
All wiring must be performed strictly in accordance with the wiring diagram located on the
middle baffle of the unit (behind of the water bucket).
Take note the fuse specifications
The unit s circuit board(PCB) is designed with a fuse to provide overcurrent protection. The
specifications of the fuse are printed on the circuit board, such as: T 3.15A/250V (or 350V), etc.
NOTE: All the pictures in the manual are for explanation purposes only. The actual shape
of the unit you purchased may be slightly different, but the operations and functions are
the same.
Note About Fluorinated Gasses
- Fluorinated greenhouse gases are contained in hermetically sealed equipment. For
specific information on the
fluorinated greenhouse gas(on some models), please refer to the relevant label on the
unit itself.
-Installation, service, maintenance and repair of this unit must be performed by a
certif ied technician.
-Product uninstallation and recycling must be performed by a certified technician.
type, the amount and the CO
28
equivalent in tonnes of the
2