Publicité
Les langues disponibles
Les langues disponibles
Follow the assembly instructions and instructions for use listed in the document supplied.
Keep these instructions in a safe place for future reference.
The maker declines all responsibility if assembling instructions are not observed or for the inappropriate
use of the product.
1.1 - This device is only usable as ski-rack and must be mounted On the roof in an horizontal position.
1.2 - Check that both the surfaces of the magnet and the roof car are dry and clean. Remove always snow, ice
or dust from the roof.
1.3 - Do not interpose any thickness of any kind between the magnetic device and the car roof.
Do not fit the magnetic ski-and snowboard rack onto vehicles with a rounded or very short rooftop design
1.4/1.5 - Carefully check to see that the rack's entire magnetic surface accurately grips onto the vehicle
rooftop.Responsibility for perfect magnetic plate operation and functions is guaranteed only if the entire
magnetic surface accurately adheres to the vehicle rooftop.
Beware of the fact that in the event of accidental rack damages(i.e. if the magnets crash to the floor) its
magnetic properties may be subject to variations (due to deformation, scratches on the magnets, etc) Thus
compromising safe device use.
If the magnetic plates are put into direct contact with one another or are kept or held next to magnetic
material, their magnetic force is considerably reduced. The magnetic plates can be influenced or damaged by
electronic devices (such as MP3 players) or magnetic storage units (such as hard disks).
The ski-and snowboard rack should not be left assembled on the rooftop for weeks on end to avoid
damaging the car paint finish.
Furthermore, window cleaner additives might seep in under the magnetic plates with an ensuing chemical
reaction causing the magnetic plate to glue down onto the rooftop surface. Exposure to direct sunlight and
high temperatures will intensify this type of reaction.
1.6 - In the presence of sun roofs the product's use demands some cautions:
a)
The device is applicable only in presence of steel sun roofs
b)
Do not put the magnetic device between the roof and the sun roof, the magnetic must be entirely
placed on the sun roof or on the whole remaining part of the roof.
c)
When the device is placed on the roof, keep it in a close position and do not run it.
During travel breaks, check the magnetic ski- and snowboard rack grip force and the position of the
skis/snowboards.
Depending on road surface and weather conditions (oncoming traffic lanes, heavy-duty trailers in tunnels,
dangerous wind gusts) possibly ensuing turbulent flows might have a negative effect on the rack load
and on the vehicle's on-road performance. In such cases, cut vehicle speed down to 80 km/h.
2.1 - Make sure, for safety reasons, that the skis are placed on the device with ends (skis' points) turned
towards the car's back.
2.2 - Adapt the distance kept between the two magnetic plates based on the actual rooftop shape and type
of skis to be carried (type of ski boot buckles). If possible, arrange for an approx. 70 cm distance between
the two magnetic plate centres.
EN
11
Publicité
