Electrical Supply - hestan GABR Serie Installation Et Fonctionnement

GAS CONNECTIONS
(continued)
INFRARED BURNER FLAME ADJUSTMENT
Infrared burners do not require adjustment and need only be checked visually for proper
performance. On HIGH, an infrared burner should glow red evenly over its entire surface. A
EN
diminished red glow and/or a large blue "halo" of flame on the surface of the infrared burner
indicates improper airflow or a blockage at the burner itself. Call for service.
SIDE BURNER FLAME ADJUSTMENT
Hestan side burners are preset at the factory for optimum performance. However, these valves
also feature a low flame (simmer) adjustment if altitude, low-heat performance, converting from
one gas to another, or other factors indicate an adjustment is needed. Follow the same procedure
as described above for Trellis Burner valve adjustment.
™
NEVER ADJUST THE SIDE BURNER SO LOW THAT IT MAY GO OUT DURING
USE.

ELECTRICAL SUPPLY

Important: This appliance must be electrically grounded in accordance with local codes, or in the
absence of local codes with the National Electrical Code, ANSI/NFPA 70-1990 .
Appliances equipped with a flexible electrical supply cord are provided with a three-prong
grounding plug. It is imperative that this plug be connected to a properly grounded three-prong
receptacle. If the receptacle is not the proper grounding type, contact an electrician. Do not
remove the grounding prong from this plug.
The grill is designed for 120 volt AC power and must be plugged into a Ground Fault Circuit
Interrupter (GFCI) protected circuit. Do not connect the grill to the electrical supply until after
gas connections have been made and leak checks have been performed.
KEEP ANY ELECTRICAL CORD AND FUEL SUPPLY HOSE AWAY FROM ANY HEATED
SURFACES.
1. To protect against electric shock, do not immerse cord or plugs in water or other liquid.
2. Unplug from the outlet when not in use and before cleaning. Allow to cool before putting
on or taking off parts.
23
©2018 Hestan Commercial Corporation