Leak Testing - hestan GABR Serie Installation Et Fonctionnement

GAS CONNECTIONS
LP TANK RESTRAINT
If you purchased a Hestan Grill on a cart, be sure to restrain the LP cylinder by securing it with
the retention bolt on the slide-out tray as shown below. It is important the tank does not fall
over or stretch the hose which could cause a gas leak.
2-STAGE
LP REGULATOR /
HOSE ASSY.
TANK
RETENTION
BOLT

LEAK TESTING

GENERAL
Although all gas connections on your Hestan grill are leak tested at the factory prior to
shipment, a complete gas tightness check must be performed at the installation site due to
possible movement in shipment, or excessive pressure unknowingly being applied to parts of the
unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is
detected.
BEFORE TESTING
• Do not smoke while leak testing.
• Never leak test with an open flame.
• Make a soap solution of one part liquid detergent and one part water for leak testing
purposes.
• Apply the solution to the gas fittings by using a spray bottle or a brush.
• For LP units, always check with a full LP cylinder.
(continued)
LP TANK
SLIDE-OUT
(SUPPLIED BY
TANK TRAY
CUSTOMER)
20 LB.
©2018 Hestan Commercial Corporation
EN
19