Best K260A Instructions D'installation page 10

All manuals and user guides at all-guides.com
14. INSTALL BAFFLE FILTERS
Remove protective plastic film covering filters before installing them.
NOTES: 1. Assemble the metal handles to the filters, using no. 8-32 x 1/4" screws provided,
before installing them in the hood.
2. A vertical arrow with the word AIR can be found on the filter border. Make sure to
install the filters with this arrow pointing toward the inside of the hood (as
illustrated below).
It is recommended to install side filters first and finish
with center one(s).
1. Insert front end of the filter inside front of the hood.
2. Raise lower end toward the inside of hood and
insert into channel.
3. Slide filter under the inner retaining piece.
HD0095
15. USE AND CARE
Baffle filters and impeller(s).
The baffle filters and impeller(s) should be cleaned frequently. Use a warm detergent solution.
Baffle filters and impeller(s) are dishwasher safe.
Remove filters by pushing filters towards the back of hood and rotating filters downward.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the
filter may occur if using phosphate detergent or as a result of local water conditions—but this
will not affect filter performance. This discoloration is not covered by the warranty.
Hood cleaning
Stainless steel cleaning: How to maintain its "BRIGHT LOOK"
Do:
• Regularly wash with clean cloth or rag
soaked with warm water and mild soap or
liquid dish detergent.
• Always clean in the direction of original
polish lines.
• Always rinse well with clear water (2 or 3
times) after cleaning. Wipe dry completely.
• You may also use a specialized household
stainless steel cleaner.
Avoid when choosing a detergent:
• Any cleaners that contain bleach will attack stainless steel.
• Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
• Any combustible products used for cleaning such as acetone, alcohol, ether, benzol,
etc., are highly explosive and should never be used close to a range.
Enamel finish:
Clean with warm water and mild detergent only. When discoloration occurs, use a good enamel
polish such as automotive polish. (DO NOT use rough abrasive cleaner or porcelain cleaner.)
CAUTION
HD0104
Don't:
• Use any steel or stainless steel wool or any
other scrapers to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction
residues reach
construction/renovation, cover the hood to
make sure no dust sticks to stainless steel
surface.
- 10 -
1
3
2
the hood. During