Troubleshooting; Maintenance - Porter Cable 513 Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

For assistance with your tool, visit our website at www.porter-cable.com for a

list of service centers, or call the Porter-Cable Customer Care Center at

5175.

KEEP TOOL CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts

should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic

parts. They could possibly dissolve or otherwise damage the material.

FAILURE TO START

Should your tool fail to start, check to make sure the prongs on the cord plug are

making good contact in the outlet. Also, check for blown fuses or open circuit

breakers in the line.

LUBRICATION

This tool has been lubricated with a sufficient amount of high grade lubricant for

the life of the unit under normal operating conditions. No further lubrication is

necessary.

BRUSH INSPECTION

For your continued safety and electrical protection, brush inspection and

replacement on this tool should ONLY be performed by an AUTHORIZED

PORTER-CABLE SERVICE STATION or a PORTER-CABLE

FACTORY SERVICE CENTER.

At approximately 100 hours of use, take or send your tool to your nearest

authorized Porter-Cable Service Station to be thoroughly cleaned and inspected.

Have worn parts replaced and lubricated with fresh lubricant. Have new brushes

installed, and test the tool for performance.

Any loss of power before the above maintenance check may indicate the need

for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL

UNDER THIS CONDITION. If proper operating voltage is present, return your tool

to the service station for immediate service.