Porter Cable 513 Manuel D'instructions page 13

LOCATING THE TEMPLATE ON THE DOOR
1. Draw a line across the door edge at the center of the mortise cut for the lock.
2. Draw a line (F) Fig. 13 on the template side guides (C), midway between bars
(B) and (E).
3. Position the template on door so that the line (F) on the template matches the
line drawn on the door edge at the center of the mortise cut.
4. Tighten the two wing screws (G) Fig. 13 to lock the template in place.
PREPARING THE ROUTER
Disconnect tool from power source!
1. Attach the 42024 template guide to the router base with 42237 lock nut.
2. Install a bit in the router collet.
3. Set the router on the lock face template. Adjust the depth of cut so that the
bit just touches the door.
4. Set the router-depth adjusting ring to the zero position.
5. Lift the router from the template. Adjust the depth-of-cut equal to the thickness
of the lock face.
6. Firmly tighten the motor-locking device.
MAKING THE CUT
Make sure router switch is in the "OFF" position.
1. Connect the router cord to the power source.
2. Mortise the door for the lock face, guiding the router by keeping the
template guide against the template guide bars.
3. A corner chisel 42234 is available as an accessory for squaring the corners
for the lock face.
FINISHED MORTISE
The completed mortise is illustrated in Fig. 14. The cut is smooth and even and
you can insert the lock box with no further hand work. In Fig. 14, the lock face
template has been used and the corner chisel has squared the corners, assuring
a perfect fit.
C
E
C
D F
G
13
B
A