Additional Specific Safety Rules - Porter Cable 513 Manuel D'instructions

ADDITIONAL SPECIFIC SAFETY RULES

1. Hold tool by insulated gripping surfaces when performing an operation
where the cutting tools may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal parts of the tool "live"
and shock the operator.
2. Do not operate the motor unit unless it is mounted in the
lock mortiser carriage.
3. Be sure cord is free and will not "hang up" during operations.
4. Keep hands clear of cutter when motor is running to prevent personal
injury.
5. Stay alert and keep cutter clear of all foreign objects while motor is
running.
6. Be sure motor has completely stopped before withdrawing cutter from
machined mortise.
7. Accessories must be rated for at least the speed recommended on the
tool warning label. Wheels and other accessories running over rated speed
can fly apart and cause injury.
8. Wear eye and hearing protection. Always use safety glasses. Everyday
eyeglasses are NOT safety glasses. USE CERTIFIED SAFETY EQUIPMENT.
Eye protection equipment should comply with ANSI Z87.1 standards.
Hearing equipment should comply with ANSI S3.19 standards.
9.
airborne particles, including wood dust, crystalline silica dust and
asbestos dust. Direct particles away from face and body. Always operate
tool in well ventilated area and provide for proper dust removal. Use dust
collection system wherever possible. Exposure to the dust may cause
serious and permanent respiratory or other injury, including silicosis (a
serious lung disease), cancer, and death. Avoid breathing the dust, and
avoid prolonged contact with dust. Allowing dust to get into your mouth
or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure, and wash exposed areas with soap and
water.
SYMBOL
V ....................... volts
A ....................... amperes
Hz ....................... hertz
W ....................... watts
kW ....................... kilowatts
F ....................... farads
µF ....................... microfarads
l ....................... litres
g ....................... grams
kg ....................... kilograms
bar ....................... bars
Pa ....................... pascals
h ....................... hours
min ....................... minutes
s ....................... seconds
n ....................... no-load speed
0
.../min or ...min - 1 ....... Revolutions or reciprocations per minute
or d.c. ............... direct current
or a.c. ............... alternating current
Use of this tool can generate and disburse dust or other
DEFINITION
SAVE THESE INSTRUCTIONS!
6