Bosch PS41 Consignes De Fonctionnement/Sécurité page 4

BM 2610007873 12-09:BM 2610007873 12-09 12/17/09 7:31 AM Page 4
Remove battery pack before changing
accessories. Accidental starting may occur
because battery appliances with a battery
inserted are in the operative condition.
Be prepared for a reaction torque when
"seating" or removing a fastener. The
screwdriver housing may tend to twist in the
opposite direction of bit rotation when
"seating" or removing a fastener depending
on the torque setting of the tool.
Do not use dull or damaged bits and
accessories. When installing an accessory,
insert the shank of the bit well within the
chuck. Be sure the chuck has locked onto
the bit correctly.
Do not run the tool while carrying it at
your side. A spinning bit could become
entangled with clothing and injury may result.
Place the tool onto the fastener only when
the screwdriver is switched off. Rotating
driver tools can slide off the fastener.
Do not use this tool as a drill. Tools
equipped with shut-off clutches are not
designed for drilling applications. The clutch
can shut off automatically and without
warning.
Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and (3)
product using battery.
Use only the charger which accompanied
your product or direct replacement as
listed in the catalog or this manual. Do not
substitute any other charger. Use only Bosch
approved chargers with your product. See
Functional Description and Specifications.
Do not disassemble charger or operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in any
way. Replace damaged cord or plugs
immediately. Incorrect reassembly or damage
may result in electric shock or fire.
Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. If battery case is cracked or
Be careful when driving long screws –
there is a risk of sliding off the fastener
head depending on type of socket or bit
used. First test the run-down of a fastener
and pay attention during the screw driving
process to ensure you do not injure yourself
if the tool bit or socket slides off of the
fastener.
W RNING
grinding, drilling and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and
other masonry products.
• Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies
depending on how often you do this type of
work. To reduce your exposure to these
chemicals, work in a well-ventilated area and
work with approved safety equipment such
as dust masks designed to filter out
microscopic particles.
Battery/Charger
otherwise damaged, do not insert into
charger. Battery short or fire may result.
Charge only Bosch approved rechargeable
batteries. See Functional Description and
Specifications. Other types of batteries may
burst causing personal injury and damage.
Charge battery pack in temperatures above
+32 degrees F (0 degrees C) and below
+113 degrees F (45 degrees C). Store tool
and battery pack in locations where
temperatures will not exceed 120 degrees F
(49 degrees C). This is important to prevent
serious damage to the battery cells.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery
liquid is caustic and could cause chemical
burns to tissues. If liquid comes in contact with
skin, wash quickly with soap and water. If the
-4-
Some dust created by
power sanding, sawing,