Blumfeldt Cascada 2G Manuel D'instructions page 17

Insert the hose (E) from below into the hand pump (D) and screw it there
with the threaded side. Be careful not to overtighten the thread.
Mount the hand pump on top of the small barrel and screw it to the barrel
with the 3 wood screws (G) (use the pre-drilled holes for orientation). Place
the pump (H) in the large barrel and lead the power cable out. Pour enough
fresh water into the barrel (about half full). Plug the water hose onto the
pump valve. Then connect the power plug to a mains outlet. The pump will
start working after a short while.
3
4
EN
17