Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

64
ATTENTION: Always remove battery when servicing or transporting the mower.
Identical replacement parts that are available from the manufacturer. In order to obtain replacement parts, the use of parts
that do not meet the original equipment specifications may lead to improper performance, and may compromise safety.
Before cleaning, repairing, or inspecting, verify that the blade and all moving parts have come to a complete stop.
Remove the battery when making any adjustments or when any of the four wheels must be lifted off the ground.
Keep the handles dry, clean, and free of oil and grease.
In order to reduce the risk of fire, keep the motor free of grass, leaves, and debris build-up.
Check the blade and motor mounting bolts for proper tightness frequently. Visually inspect blade for damage
(e.g., bent, cracked, or worn).
For best and safest performance, maintain the mower with care. Keep the mower blade sharp and clean. Mower
blades are sharp, and can cut. Wrap the blades or wear gloves, and use extra caution when servicing.
Keep all nuts, bolts, and screws tight in order to be sure that the equipment is in safe working condition.
Never tamper with safety devices. Check them regularly for proper operation.
After striking a foreign object, stop the motor. Thoroughly inspect the mower for any damage. Repair any
damage before operating the mower.
The grass catcher components, discharge cover, and trail shield are subject to wear and damage, which could expose
moving parts or allow objects to be thrown. As a safety precaution, check these components frequently, and immediately
replace any parts that show signs of wear, or that are cracked or broken. Use original equipment manufacturer's parts only.
When it is not in use, store the mower indoors in a dry area, and out of the reach of children.

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
The battery is not charged.
The switch is defective.
The mower does
Grass jammed between the deck and blade.
not start.
The battery is not fully inserted in the mower.
Battery may require service or replacement.
The lawn is rough or uneven.
The mower cuts
the grass unevenly.
The cutting height is not set properly.
Wet grass clippings are sticking to the
The mower
does not mulch
underside of the deck.
properly.
The mulching plug is missing.
The grass is too tall, or the cutting height is too
low.
The mower is
hard to push.
The rear of the grass catcher bag is dragging in
thick grass.
The mower is
The motor shaft is bent.
excessively noisy
The blade is unbalanced.
and vibrates.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
POSSIBLE CAUSE
SOLUTION
Charge the battery.
Replace the switch
Remove battery; check under deck for jams.
Check the connection between the battery
and the mower. Make sure the battery clicks
into place.
Replace battery.
Check the mowing area.
Move the wheels to a higher setting.
Wait until the grass dries before mowing.
Install the mulching plug.
Raise the cutting height.
Empty the grass clippings from the grass
catcher bag.
Stop the motor, and inspect for damage.
Repair before restarting.

Publicité

Table des Matières
loading

Table des Matières