Canceling The Initial Setting Mode; Collective Deletion; Setting The Slave Controller - Mitsubishi Electric PAC-SC30GRA Manuel D'utilisation

7-1-3. Canceling the initial setting mode

• Press the FILTER sign reset switch and
seconds) when the group settings and linked equipment settings have been completed.
• This will store the group setting information and perform system start-up communications. Once this
has been completed, the user operation screen will be displayed. (Refer to 7-1. 1 (ii))
NOTE: Do not switch off the power supply during system start-up communications (when [H1] is
blinking.)
(The group setting information will be stored incomplete if the power supply is cut off.)

7-1-4. Collective deletion

Deletes all group setting information and interlocked unit setting information.
(1) Display the initial setting mode screen or the interlocked unit setting screen.
(2) Press the fan speed switch with this displayed for three or more consecutive seconds to
delete all setting information.
CENTRALLY CONTROLLED
CHECK ON
ADDRESS
˚C
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
CHECK ADDRESS ON
˚C
COLLECTIVE
GROUP
Initialized status

7-2. Setting the slave controller

• Initial settings are performed with the master system controller when this equipment is controlled by
the master system controller.
(It is not necessary to enter initial settings.)
NOTE: Observe the system limitations mentioned in *1 of 2. Functions when making the initial settings
with the master system controller.
Press the
consecutive seconds
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
horizontal blow switch simultaneously (for at least two
fan speed switch for three or more
The switch LED and the selection mark will blink
ON/OFF
Communications process for collective deletion in
progress
[ ] will blink in the room temperature display area
23