Group Settings - Mitsubishi Electric PAC-SC30GRA Manuel D'utilisation

7-1-1. Group settings

Register the indoor units into each group.
Register the remote controller and the slave system controller in the same way.
1 Select the group
Select the group for which unit registration is required.
2 Select the unit
Select the unit to be registered into the group selected in 1.
3 To register units in groups
4 To delete units from the group
5 To confirm registered units
↓
Refer to 7-1-2 or 7-1-3.
NOTE: The range of the address number settings for the remote controller is between 201 and 250.
Group allocation for the eight groups are automatically assigned a group number. (The controlled
group is between group remoter controller address minus 200 and group remoter controller
address minus 200+7.)
Example: When the group remote controller address is 201, the controlled groups are
between groups 1 and 8. When the group remote controller address is 209, the
controlled groups are between groups 9 and 16.
1 Select the group
(1) The cursor in the group display area will move in the following sequence whenever the
GROUP select switch is pressed. It will move in the opposite direction when the
pressed.
Example: When the group remote controller address is 201
Cursor movement
Room temperature display area (group number
displayed for two seconds.)
• The controlled group display will change in accordance with the address number setting.
14
Address of PAC-SC30GRA
201
209
Controlled group number
1 to 8
9 to 16
1
5
Group display area: Group number
allocation
" " " " "
switch is
2 3 4
6 7 8
" " "
• • • •