Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V4.5
3.
Alert other people in the work area, so they can take precautions or can
watch out for those with a pacemaker.
USE AND CARE OF THE TOOL
1.
Use the correct tool for the job. This tool was designed for a
specific function. Do not modify or alter this tool or use it for an
unintended purpose.
2.
Do not carry the tool with fingers near or on the trigger/switch.
3.
Avoid unintentional starts. Be sure that the ignition switch/trigger is in the
neutral or OFF position when not in use or before connecting it to any
power source.
4.
Remove adjusting keys and wrenches from the tool before operation or
connecting it to a power source. A wrench or key that is left attached to a
rotating part of the tool increases the risk of personal injury.
PARTS IDENTIFICATION
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
Contents:
•
Jackhammer
•
Hex Wrench
INSTALLATION
INSTALL ACCESSORIES
1.
Pull out the bolt (Fig. 1-1) and swivel it to turn the
flange towards the direction of the motor housing.
2.
Insert accessory into the tool holder through the
dust shield (Fig. 1-2), while twisting and pushing
inward until it locks automatically into place.
Visit www.princessauto.com for more information
120V AC Electric Jackhammer Kit
• Sharp Point Chisel, Hex 16 in. (Replacement 8525180)
• Flat Chisel, Hex 1-1/8 in. x 16 in. (Replacement 8525206)
1-1
8520892
1-2
Fig. 1
9
Publicité
Table des Matières
