Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8520892
AUXILIARY HANDLE
1.
The tool must be supported with the auxiliary
handle (Fig. 2-1), which can be swiveled 360
2.
To reposition and/or swivel the handle, loosen
the hand grip (Fig. 2-2), move the handle to
the desired position along the barrel (Fig. 2-3)
and securely retighten the hand grip.
OPERATION
WARNING! Chipping and breaking concrete and stone can create stone
chips. Wear protective eyewear and clothing while using the jackhammer.
Clear the area of bystanders unless they are also wearing personal
protective equipment.
1.
Warm up the tool before the first use of the day or when left unused for a
time in cool temperatures. This may take several minutes.
2.
Place the tip against the workpiece at an angle away from yourself. This
will cause the bit to break the material apart as you move.
a.
Do not hold the jackhammer straight up-and-down as the bit will
create a hole in the material instead of breaking it apart.
3.
Press the trigger to start the jackhammer.
a.
Squeeze the trigger to start the tool
(Fig. 3-1).
b.
Press the locking button (Fig. 3-2) to
allow the tool to run without holding
the trigger.
c.
Press the trigger again to release the
lock and stop the tool.
4.
Maintain a firm grip to prevent the hammer chisel from slipping or
bouncing around and causing an injury or unintended damage.
5.
Apply just enough pressure to guide the jackhammer. The tool's own
weight will generate the force to break and demolish the workpiece.
6.
Release the trigger when the job is complete.
10
120V AC Electric Jackhammer Kit
For technical questions call 1-800-665-8685
.
o
2-1
2-3
3-1
V4.5
2-2
Fig. 2
3-2
Fig. 3
Publicité
Table des Matières
