English - Kenwood JK820 Mode D'emploi

safety
G
Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.
G
Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down.
G
If you do not need so much cord,
shorten it by winding any excess
cord inside the powerbase.
G
Always unplug your kettle
when not in use.
G
Never overfill - boiling water may
splash out.
G
Never put the kettle, powerbase,
cord or plug in liquid.
G
Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
'service'.
G
This kettle is not intended for use by
young children or infirm persons
without supervision.
G
Young children should be supervised
to ensure they do not play with the
appliance.
G
Caution: Do not operate the kettle
on an inclined surface.
G
Only use the powerbase supplied
and keep it clean and dry.
G
Make sure the lid is secure before
switching the kettle on.
G
Warning: Do not open the lid while
the water is boiling.
G
Take care when opening the lid -
droplets of hot water may be
ejected.
G
Make sure the kettle is switched off
before lifting or pouring.
G
Remove the kettle from the base
before filling or pouring.
G
Never put the kettle near or on
cooker hot plates or gas burners.
G
This kettle is for boiling water only.
G
This kettle is for domestic use only.
G
Failure to observe these cautions
may result in damage to the kettle.

English

before plugging in
G
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
G
This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
G
Remove all packaging and any
labels.
G
Adjust the length of the cord - turn
the underside of the base clockwise
to lengthen and anticlockwise to
shorten the cord.
G
Fill to 'MAX', boil, then pour the
water away.
key
flip top lid
on/off switch
neon light
360° powerbase
water level windows
lid release trigger
scale filter
cord storage
to use your jug kettle
1 Fill it through the spout or lid. To
open the lid, press the lid release
trigger. The water level must be
between 'MAX' and 200mls (1 cup).
G
Be economical: do not boil more
water than you need.
G
To improve the quality of your drinks
always use fresh water.
G
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The neon will
come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
G
Your kettle is fitted with a scale filter
to hold back limescale particles.
G
If you find drops of water under your
kettle, don't worry - it is just
condensation.
2