Filling The Solution Tank - Sanitaire HydroClean SC930 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1624634_FloorWasherCS930.qxp_English 2/5/21 11:14 AM Page 6
FILLING THE SOLUTION T NK
WARNING
!
Fill with warm (140°F/60°C MAX) tap water and add the recommended formula.
DO NOT USE BOILING WATER. DO NOT HEAT WATER OR TANK IN MICROWAVE.
1
The solution tank
is located on
the back of the
floor washer.
4
Only for Sanitaire solution:
1. Fill solution tank with 5 ounces of Sanitaire
cleaning or sanitizing solutions.
2. Fill the remainder of the solution tank with
warm tap water to Maximum Fill Line.
(Water to solution ratio = 6:1)
5
Screw the cap back onto the solution tank.
6 www.sanitairecommercial.com
2
Lift the solution tank
straight up to remove from
the floor washer.
For other recommended solutions:
1. Fill solution tank with "ready to use"
(pre-diluted) formula to Maximum Fill Line.
2. Follow manufacturers recommended
solution ratio for cleaning and sanitizing
hard floors.
6
3
Unscrew the cap from the
solution tank.
On the back of the floor
washer, align solution tank
with the grooves and slide
tank into place until you
hear a click.
click

Publicité

Table des Matières
loading

Table des Matières