Husqvarna Rider 322T AWD Manuel D'utilisation page 14

13. Attach the front cover.
To remove the cutting deck
1. Park the product on level ground and apply the
parking brake.
2. Set the cutting height lever in the servicing position.
3. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck.
4. Release the clip on the front cover with the tool
attached to the ignition key, and lift off the cover.
5. Pull the spring handle out from the spring holder to
loosen the drive belt tension.
6. Put the spring handle hook on the edge of the
equipment frame.
7. Remove the drive belt and put it in the belt holder.
14
8. Lift the cutting height stay and put it in the holder for
the cutting height stay.
9. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
10. Push the equipment frame down. Lift the equipment
frame lock to vertical position.
WARNING: The lock mechanism can
cause injury to fingers if you do not
operate it carefully. Put the equipment
frame lock in full vertical position. Hold
the front edge of the cutting deck with
two hands when you continue to the next
step.
11. Pull the cutting deck out.
270 - 001 - 28.11.2017