Publicité
Les langues disponibles
Les langues disponibles
WARNING: If the chain and motor fail to stop when the
chain brake is engaged, take the chainsaw to the nearest
professional service centre. Do not use the chainsaw if the
chain brake is not in proper working order.
GENERAL CUTTING INSTRUCTIONS
• FELLING
Felling is the term for cutting down a tree. Small trees up to
15-18cm in diameter are usually cut through in a single cut. Larger
trees require notch cuts. Notch cuts determine the direction the
tree will fall.
WARNING: A retreat path (A) should be planned and
cleared as necessary before cuts are started. The retreat path
should extend back diagonally to the rear of the expected line
of fall, as illustrated in Fig. 2.
WARNING: If felling a tree on sloping ground, the
chainsaw operator should stay on the uphill side of the
terrain, as the tree is likely to roll or slide downhill after it has
been felled.
Fig. 2A
Fig. 2B
13
Publicité
