Publicité
Les langues disponibles
Les langues disponibles
Switching On / Switching Off
The mains voltage must match the voltage on the rating plate
of the chainsaw. Hold the chainsaw with both hands when
starting up and during operation.
Switching on: Press the switch lock button (13) then the power
switch (7).
If the chainsaw does not start, release the brake lever (1).
Switching off: Release pressure on the switch (7).
Operating the Chainsaw
Before starting to cut, pull the brake lever (front hand guard)
back towards the front handle.
Before plugging in, check the plug and cable for damage. If
damage is discovered, have it repaired by a specialist
immediately. Never use a damaged cable, connection or plug,
or a power cable that does not comply with the requirements.
The power cable must always be behind the chainsaw
operator.
Always start cutting with the chainsaw already switched on.
When starting the chainsaw, its saw chain must not be resting
on the material being processed.
Move the chainsaw away from the material being cut only
when the saw chain is working.
If the cut cannot be completed in one run, slide the chainsaw
out, position the bumper spike and continue the cut by lifting
the rear handle.
Switch off the chainsaw engine before releasing the chain
brake.
Do not let the chainsaw touch the ground while it is running.
The chainsaw heats up considerably during operation. Be
careful and do not touch hot parts of the chainsaw with
unprotected parts of your body.
Always stand to the side of the predicted fall line of a tree that
is to be cut.
10
Publicité
