Using The Comb Attachment; Using The Trimmer - Panasonic ER-GB370 Mode D'emploi

Using the comb attachment

Make sure that the trimmer is turned off.
1. Turn the dial to the "1" position.
2. Mount the comb attachment to the
main body until it clicks.
3. Turn the dial to the desired indicator
(between 1 mm (1/32˝ ) and 10 mm (13/32˝ )).
Indicator 1
Trimming mm 1 1.5
height
inch 1/32 1/16 5/64 3/32 1/8 9/64 5/32 11/64 3/16 7/32
(estimate)
Indicator 6
Trimming mm 6 6.5
height
inch 15/64 1/4 9/32 19/64 5/16 11/32 23/64 3/8 13/32
(estimate)
When trimming a short beard, it is effective to increase the
number of trimming times in order to keep the beard uniform
at the desirable length.
It can also be used without the comb attachment.
(Trimming height: approx. 0.5 mm (1/64˝ ))
Actual hair length will be a little longer than the height you set.
10
PB013743 - ER-GB370 _(01EN)_07-22-16.indd 10
2 3 4 5
2 2.5 3 3.5 4 4.5 5
7 8 9 10
7 7.5 8 8.5 9 9.5 10

Using the trimmer

Make sure there is no damage to the blade.
The appliance may not operate in an ambient temperature
lower than approximately 0 °C (32 °F).
Dry trimming
Trimming with the comb attachment
Do not use when the beard is wet.
A wet beard may stick to the skin or bunch up, making it
difficult to trim.
1. Mount the comb attachment and adjust the dial.
(See this page.)
2. Slide the power switch to the " "
position to turn on the trimmer.
5.5
3. Hold the trimmer with the power
switch facing upward, and cut the
beard by moving the trimmer back
against the flow of the beard.
Hair trimmings may collect inside the
attachment when a large volume of
beard is cut, so discard hair trimmings
after each use.
2016/7/22 10:31:28