Siemens RCR114.1 Guide Rapide page 3

Overview
RCR114.1 is a wireless single-zone receiver that can be used together with the Smart Thermostat
RDS110.R either as a wireless relay or as a repeater. When used as a relay, the receiver is wired
to the heating equipment and receives the wireless control signals transmitted by the RDS110.R.
When the receiver works as a repeater, it will extend the reach of the RDS110.R control signals.
Setting RCR114.1 as a wireless relay or repeater
You can set the DIP switch on the rear of the front module to set RCR114.1 as relay or repeater.
Default setting. Indicate that the
device is working as a wireless
relay.
Setting the DIP switch
1. Power off the device if already mounted.
2. Detach the front module by unscrewing the screw at the bottom of the device.
3.
On the rear of the front module, set the DIP switch as needed using a screw driver.
Connecting to the Smart Thermostat (RDS110.R)
The device connects to the RDS110.R thermostat via radio frequency signals on the Thread
protocol at 2.4 GHz. After the connection between thermostat and receiver is established,
reconnection is not needed, even after a power outage.
A6V11562447_en--_a
Indication of data transmission and operating state (LED)
Initialization of wireless communication with transmitter (Button)
Indicate that the device is working as
a repeater that helps to extend
network coverage.
en
1 / 20