Yakima FrontLoader Mode D'emploi page 4

Wheel Setting
Look at your bike's tire to find
your wheel size. Open the red
levers on the wheel hoop to
adjust wheel grip height.
Load bike.
Lift your bike up and align front wheel
with hoop while rolling forward. The
small hoop will lever up.
Do not use this product If your bike has fenders that
prevent the hoops from direct contact with the tire.
Secure rear wheel.
• Thread strap
through spokes,
and insert it into
the slot in the
wheeltray.
• Do not let strap
push against
valve stem.
1033644D-4/18
Slide the wheel grip until the
number matching your wheel size
is visible through the window.
IMPORTANT: Make sure to check your bike tire sidewall for your tire size. The
larger tire size settings have markings for both road and mountain bike tire size
ranges. Always use the size range setting that corresponds with your tire size.
Open wheel hoop.
CENTER TIRE IN
WHEELGRIP
CLOSE RED
LEVERS.
Tuck wheelstrap
into the slot to
make way for
the tire.
Pull down on wheel while
turning the knob clockwise
to tighten hoop.
• Pull hard to
tighten.