Kohler 1075256 Guide Rapide

SERVICE KIT INSTRUCTIONS
Spout
Supply
Hoses
Faucet/Hose
Connection
Hose
Remove
Turn off the water supply, then rotate the faucet handle to relieve water pressure.
Remove the sprayhead from the hose.
Remove and retain the weight from the hose.
Disconnect the hose from the faucet/hose connection.
Firmly pull the hose from the spout.
Discard the hose with washers.
Install
Rethread the sprayhead onto the new hose.
Feed the remaining end of the new hose into the spout.
Reattach the weight 9" (22.9 cm) from the end of the hose.
Make sure both hose ends of the faucet/hose connection are clean and free of
debris.
Place the rubber washer into the end of the hose.
Thread the faucet/hose connection and the hose together until the rubber washer
compresses.
Verify the faucet/hose connection is secure.
Checkout
Turn on the water supply.
Move the handle to the ON position.
Check for leaks and proper operation.
Extend and retract the hose to check for proper operation. Adjust the supply hoses
or weight, if necessary.
©2008 Kohler Co.
Rubber
Washer
Weight
1
Spout
Plastic Washer
Seal Retainer
HOSE ASSEMBLY
1075256
Hose
O-Ring
Screen
Gasket
Sprayhead
1089448-9-A