MSI 880GM-E35 Mode D'emploi page 27

adjust turbo Core Ratio
this item is used to specific the turbo Core frequency multiplier.
adjusted turbo Core Freq. (mHz)
it shows the adjusted turbo Core frequency. Read-only.
unlock CPu Core
this item is used to unlock the CPu core. Please refer to the procedures below for
CPu core unlocked in BioS setup.
enter "Cell menu" and set "unlock CPu Core" to [enabled].
Save changes and exit the BioS setup.
you will see the "X4" (quad core) or "X2" (dual core for
Sempron series only) during PoSt.
amd Phenom(tm) ii X4 Processor
amd Sempron(tm) ii X2 Processor
imPoRtant
* this CPu core unlocked behavior depends on the CPu ability/ characteristic,
and it is not guaranteed.
depend on CPu's characteristic, once you get instable scenario, please restore
*
the default settings for system.
you can also check the core numbers in performance tab of Windows task man-
*
ager.
advanced Clock Calibration
this item is for overclock. Setting to [enabled] allows you to set the CPu Ratio
higher. it is available only when the processor supports this function.
CPu Core Control
this item is used to control number of CPu cores. When set to [auto], the CPu will
operate under the default number of cores. When set to [manual], you will be able
to enable/disable the specific CPu core.
Core / 2/ / 4
these items are used to enable/disable the core / 2/ / 4.
oC Genie Lite
Setting this item to [enabled] allows the system to detect the maximum FSB clock
and to overclock automatically. if overclocking fails to run, you can try the lower
FSB clock for overclocking successfully.
26
System restart.
Success
Set "adjust CPu-nB Ratio" and
"Ht Link Speed" to [x8].
Clear CmoS data.
Fail
the CPu does not support CPu core
unlock, please leave the default settings
for system.