Etherma ET-71 Manuel page 25

3. Connect power, voltage 230 VAC,
load and floor sensor cable.
Any extension to the floor sensor cable
must be by means of high-voltage
current. Protective conductor for
incoming feed and for heating cable
is connected with a connection clip in
the box. See wiring diagram below.
4. Insert the thermostat into the ap-
pliance box and screw tight with the
existing screws.
5. Read the How the thermostat works/
Regulating functions section on how to
set the regulating functions.
6. Mount frame, front and knob.
7. If the thermostat is mounted in a
multi-compartment frame, the internal
corners of this frame must be removed.
N
L
LOAD LOAD
230 V
23 23