Horizon Global 76632 Instructions D'installation page 4

1. Trim underbody panel – Using a flat head screwdriver remove plastic push
rivets from the bottom of the underbody panel, find and mark the center of
the panel and trim 1.75" (3.5" total) from each side of center See Figure 2.
NOTE: BE SURE TO CHECK THE AREA FOR SENSOR WIRES THAT MAY NEED TO
BE MOVED BEFORE TRIMMING.
3a. Install hitch– Remove the covers from weldnut holes on the frame rail if
present. Use wire brush to clean the weldnuts if needed.
©2022 Horizon Global Americas Inc. - Printed in Mexico
Lower large underbody panel - Using a 10mm socket remove nuts from
2.
underbody panel to lower panel for hitch installation See Figure 3.
3b. Place the spacer plates on the frame rail in the area of the weldnuts. Raise
the hitch into position. NOTE: BE CAREFUL NOT TO DAMAGE WIRING IN THE
AREA OF THE HITCH.
Sheet 4 of 15 76632NP 10-24-22 Rev. A