Horizon Global 76632 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Frame rail
①②
Conical Washer
Teeth side
Against hitch Figure 1
1. Trim underbody panel – Using a flat head screwdriver remove plastic push rivets from the bottom of the underbody panel, find and mark the center of the panel and trim
1.75" (3.5" total) from each side of center See Figure 2. NOTE: BE SURE TO CHECK THE AREA FOR SENSOR WIRES THAT MAY NEED TO BE MOVED BEFORE TRIMMING.
2. Lower large underbody panel - Using a 10mm socket remove nuts from underbody panel to lower panel for hitch installation See Figure 3.
3. Install hitch– Remove the covers from weldnut holes on the frame rail if present. Use wire brush to clean the weldnuts if needed. Place the spacer plates on the frame rail
in the area of the weldnuts. Raise the hitch into position. NOTE: BE CAREFUL NOT TO DAMAGE WIRING IN THE AREA OF THE HITCH. Align the attachment holes in the hitch
with the holes in the spacers and weldnuts, apply blue thread locker to bolts, install the supplied bolts and conical washers (Teeth side toward hitch).
4. Tighten all M12 fasteners to 76 ft.lb. (103 N*m) with torque wrench.
5. Reinstall underbody panel - Reinstall trimmed underbody panel, raise and reinstall large underbody panel
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which
has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety
specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2022 Horizon Global Americas Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76632, 84632, CQT76632
Fasteners
typical
both sides
Weldnuts
typical
both sides
Spacer plate
①②
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 3 of 15
Fastener Kit: 76632F
① Qty. (6) BOLT M12x1.25x50mm Cl10.9
② Qty. (6) WASHER CONICAL 1/2"
*Spacer plates are not in the fastener kit.
They are attached to the hitch.
3.5"
Figure 2
Figure 3
76632NP 10-24-22 Rev. A