Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Install hitch - Using pull wire, feed the carriage bolts and spacers into frame rails and bracket holes from forward most frame rail hole. Raise hitch into position and
align holes with holes in frame rail. Remove pull wires and loosely install M8 bolts, conical washers, flat washer and hex nuts to hitch, see Figure 1.
7. Tighten all 1/2-13 Gr5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M). Tighten all M8 fasteners with torque wrench to 20 Lb.-Ft. (27 N*M)
o
m
o
n
Drilled Holes
Exhaust
Hanger
Brackets
②
p
l
②
q
q
l
Figure 1
8. Reinstall exhaust and sensor – Raise exhaust back into position and secure sensor in place using original hardware removed in step 2.
©2022 Horizon Global™ Corp - Printed in Mexico
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Frame Rail
Access Hole
Sheet 7 of 21
76626NP
10-3-22
Rev. A
Publicité
Table des Matières
