Horizon Global 76626 Instructions D'installation page 5

2. Lower exhaust – a.) Using 10mm socket, remove (1) bolt from rearward driver exhaust hanger. Repeat step for passenger side. NOTE: Disconnect sensor on
passenger side exhaust prior to lowering. b.) Using 16mm socket, remove (2) bolts from mid vehicle exhaust hanger. Set aside for later use.
3. Remove/Trim heat shield/Reinstall – a.) Using 8mm socket, remove (2) screws from underside of vehicle (found near exhaust (1) per side). Then remove (4) nuts
from the center of the heat shield using the same socket. Gently remove and set aside for later use.
©2022 Horizon Global™ Corp - Printed in Mexico Sheet 5 of 21 76626NP 10-3-22 Rev. A