Installing The Mounting Bracket - Faro Barcelona Nisos 33363 Instructions Pour L'installation Et Le Fonctionnement

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / Ο∆ΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ
PREPARATION:
Verify you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor
from packing. To avoid damage to finish, assemble motor on soft padded surface or use the original foam inset in motor box.
Do not lay fan on its side as this could result in shifting of motor in decorative enclosure.

INSTALLING THE MOUNTING BRACKET:

Caution:
To avoid possible electrical shock, be sure electricity is turned off at the main power box before
writing. All wiring must be in accordance with National and Local Electrical Codes and the ceiling
fan must be grounded as a precaution against possible electric shock.
Attach the hanger bracket to outlet box using screws provided. Install square rubber washer.
To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked
acceptable for fan support and use mounting screws provided with the outlet box. Consult a qualified electrician if in doubt
INSTALLING THE FAN
HANG DOWN STYLE
Slide the canopy and yoke cover on the downrod. Thread the power leads from the fan through the canopy yoke cover, and
downrod. Take extra care not to pull on power wires damage and loose connections could result from any abnormal pressure on
these wire. Set downrod into yoke. Rotate until the holes match. Be careful not to damage the wiring insert connector pin through
the holes. Secure the pin by insert the stop pin through the connector pin.
Nisos – ref. 33363 faro - 14