Girard Products WUD Serie Manuel Du Propriétaire page 6

Figure 2
2. Solenoid Valve.
The Solenoid Valve may be located in either of two locations: Option 1: attached to the Hot Water
Outlet on the back of the Water Heater (recommended) and plumbed both to the Hot Water System
AND the fresh water tank; or Option 2: somewhere between the Water Heater and the Fresh
Water Tank and plumbed to the system and the fresh water tank. Regardless of location, it must
be plumped properly to function correctly. Consult your OEM for the location if installed at time of
production.
Note: In certain aftermarket installations access to the fresh water tank may not be possible. The solenoid out water line can
be connected to a drain or routed to the ground but be aware that a patch of ice may form under the RV which may cause a
hazardous condition.
CRITICAL INSTALLATION WARNING!
• The Solenoid Valve must be located where it is easily accessible should service be required.
Girard will not be responsible for labor charges to locate and make accessible.
6