Publicité
Les langues disponibles
Les langues disponibles
HEAD LAMP GUARDS WITH STIFFENER BRACKETS:
Install 5/16-18 x 3/4" button head screw, flat washer and lock washer through lower curved bracket and into the threaded inserts in
1.
the back of the center tube.
2. Attach the stiffener bracket to the winch carrier as shown below using 7/16 x 1 1/4" hex bolts, flat washers, lockwashers and hex
nuts.
3. Repeat steps 1 through 5 for other side.
4. Tighten all bolts to the torque specified. Ensure all bolts are tight and headlamp guards are secure.
Warn Industries Inc.
Large Frame Carrier shown: Mid Frame Carrier similar.
(Diagram may vary depending on vehicle.)
PAGE 3
4X 71/6-14 X 1 1/4" HEX BOLT
4X 71/6 FLAT WASHER
4X 71/6 LOCK WASHER
4X 71/6-14 HEX NUT
80332 Rev. A3
Publicité
