ShelterLogic ShelterCoat Peak 28 x 16 Instructions De Montage page 6

20'x20'x16' is the base frame dimension. Your model may have more middle ribs than shown in the illustration
on page 3. You will receive one extra rib for every extra 4 ft. of building length that you purchase. The basic
frame assembly will remain the same. The cover will be the correct size for the length of the building.
1. PLOTTING THE FRAME:
Before building your shelter, you should choose a flat area on
your property and plot your shelter.
A. Stake out the area for the shelter in the desired spot. The width of
the area should be at least equal to the width of the shelter and the
length should be equal to the length of the shelter Fig. 1.
B. Measure diagonally from corner to corner (A & B). These
measurements should be the same. If they are not equal the stakes
need to be adjusted until the width, length and inside measurements
are correct.
2. ASSEMBLE END RIBS
Assemble end ribs as shown in Fig. 2. Securely
fasten all of the joints with the hardware indicated.
Fig.2
800385
800386
NOTE: FRAME EXTENSION KIT
800384
800390
800435
800383
800391
800384
800389
Use #11131
5/16" x 2 3/4" L
Bolts
Page 6
28 ft.
WIDTH
A
B
800385
800386
800435
05_GP-AA-XXXXXXA-028XXX16_H0
BUILDING
LENGTH
Fig.1