Important - ShelterLogic ShelterCoat Peak 28 x 16 Instructions De Montage

10. END AND DOOR PANEL INSTALLATION
A. Hold end panel at the top center with white inner surface facing inside of the shelter. (If you purchased the white cover,
the inner face has the visible weld seams at the webbing pocket.) Wrap the edges of the fabric panel around the
end rib.
B. Disconnect top cross rail (the horizontal pipes that run from front to back along the top) from the end rib. Pull the
webbing (the black strap) below the cross rail. Reattach the top cross rail to the end rib.
C. Remove the nut from the side rail and carefully pull the side rail away from the ShelterLock
pass the webbing through the connection). If this connection has the wind brace on it remove the wind brace end
before pulling the side rail. Replace the cross rail and wind brace. Replace the nut and tighten. Repeat this on the
other side.
D. At the bottom, where the webbing exits the pocket on each side of end panel, pull webbing to remove the slack. Be
careful not to pull the webbing through the other side of the webbing pocket.
E. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet and pull tight.
Wind the ratchet so that the webbing overlaps itself.
Position the end panel so that it is centered on the building before fully tightening the end panel.
F. Tighten ratchets, alternating from one side to the other, until the end panel is centered and tight.
WRAP END PANEL EDGES OVER AND AROUND PIPE TOWARDS INSIDE OF FRAME.

IMPORTANT!

Fig.10
Thread
Webbing
Into
Ratchet
NOTE: Keep Zippers closed when tightening end panels.
DO NOT INSERT ANY PIPES
INTO THESE POCKETS.
ZIPPERS
WEBBING
INSIDE VIEW OF END RIB
TOP CROSS
Webbing
and
Ratchets
Securing
End Panel
Page 11
(pull away only enough to
®
RAIL
SIDE
CROSS RAILS
WIND
BRACE
SIDE VIEW OF END RIB
05_GP-AA-XXXXXXA-028XXX16_H0
WRAP END
PANEL
EDGES
TO INSIDE
OF FRAME