Operations
04 Ice Maker / Filter Reset (3 sec)
Ice Maker
Filter Reset
05 Door Alarm / Peak Demand Off (3 sec)
Door Alarm
Peak Demand Off
34
English
Untitled-2 34
Press Ice Maker to turn the ice maker on or off.
The ice maker has 2 indicators (
indicate its operating status.
• When the ice maker operates, the corresponding indicator
(
) turns on.
• When the ice maker is turned off, the corresponding indicator (
) turns on.
After about 6 months (and typically, about 300 gallons (1200 L)
of water), the Filter Reset indicator blinks red for several seconds
when you open the door, reminding you that the filter needs to be
replaced.
When this happens, replace the filter, and then press and hold Ice
Maker for 3 seconds. The filter lifecycle will be reset and the Filter
Reset indicator turns off.
NOTE
• Some regions have relatively large amounts of minerals in
their water. This can reduce the lifecycle of the filter. In these
areas, you will have to replace the water filter more often than
specified above.
• If water is not dispensing properly, the water filter is most
likely clogged. Replace the water filter.
If the door is left open for more than 2 minutes, an alarm will
sound and the alarm indicator will blink. You can toggle the alarm
on and off by pressing Door Alarm. The alarm is enabled by
factory default.
If the door is left open for 5 minutes, interior light (in the fridge,
freezer) will blink for 5 minutes and turn off. It is to alert deaf and
hard of hearing users that a door is open. Note that this function
is normal.
The Peak Demand Off function activates/deactivates Smart Grid.
Press Door Alarm for 3 seconds to set/clear the Peak Demand Off
function.
When the function is enabled, the Peak Demand indicator (
turns on with a chime.
For more information, see the SMART GRID Function (Demand
Response) (applicable models only) section.
/
) to
)
2022-11-09
12:02:20