Rothenberger RODRUM M/L Instructions D'utilisation page 25

6.1 Inserting new spirals
 Move the spirals with the feed unit completely from the drum and unfasten the coupling.
 Connect new spirals with the connecting piece and push in the spirals up to about 30cm.
7 Troubleshooting
Symptom
The machine does not start
No feed
8 Accessories
You can find suitable accessories in the main catalog or at www.rothenberger.com
9 Customer service
The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using RO SERVICE+
online: ℡ + 49 (0) 61 95/ 800 8200
www.rothenberger.com
10 Disposal
Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmental friendly dispos-
al of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
For EU countries only:
Do not dispose electric tools with domestic waste. In accordance with the European
Directive 2012/19/EU the disposal of electrical and electronic equipment and its imple-
mentation as national law, electric tools that are no longer serviceable must be collected
separately and utilised for environmentally compatible recycling.
Possible Reason
No power supply
Motor defective
Switch off the PRCD
The foot switch / com-
pressed air hose is defective
Ball bearing in the feed unit
is defective
Spiral defective
+ 49 (0) 61 95/ 800 7491  service@rothenberger.com -
ENGLISH
Solution
Check the power supply
network
Contact our Customer Ser-
vice Department
Press the RESET button
(PRCD)
Contact our Customer Ser-
vice Department
Contact our Customer Ser-
vice Department
Replace the spiral
19