Rothenberger RODRUM M/L Instructions D'utilisation page 22

5.2.1 Height adjustment of the transport handle
 Open both locking bolts and lock this through turning through 90°.
During opening, hold the handle in position!
 Select the suitable handle height. According to the application there are four selectable han-
dle settings. The lowest handle position is the setting for transport in a vehicle.
 Turn both locking bolts back into the locking position.
Ensure that both locking bolts audibly engage; if necessary check through light shifting!
5.2.2 Loading the pipe cleaning machine
 Place the pipe cleaning machine backwards into the loading area of the vehicle.
 Select the suitable handle height according to 5.2.1.
 Tip the pipe cleaning machine with the transport wheel on the loading area of the vehicle.
 Raise the pipe cleaning machine with both hands and push this completely onto the loading
area.
When raising the pipe cleaning. select a back-friendly
operating method, crouch down first before lifting with both
hands or two people lift the pipe cleaning machine as a
pair!
 Place the pipe cleaning machine in the vehicle so that this does not slip during the drive.
Never transport the pipe cleaning machine lying down!
 Stow away the cable in a manner suitable for transport.
5.3 Commissioning
The pipe cleaning machine should exclusively be operated by instructed and authorized
personnel!
 Check the electrical installation at the work place.
 Place the foot switch in such a way that it can be easily reached and that all control ele-
ments are easy to operate.
 Push the guide tube over the spiral up to the dead stop on the feed unit housing and fix in
place with the catch.
 Connect the mains power plug to the appropriate power supply network.
Ensure that the motor switch is set to "OFF"! Never use the cleaning device without a
footswitch and guide hose!
5.4 Coupling/ Decoupling the tools / spirals
 Remove the tool box from the holding device (see Figure D).
 Select the suitable tool for use.
Coupling:
 Push the tool / spiral until it engages with the coupling and check for firm seating.
Decoupling:
 Push the segregation key into the bore and push the tool / spiral to the side out of the cou-
pling.
16 ENGLISH
(B)
(C)
(A/D)