Problems With Your Appliance; Troubleshooting Guide - Summit Classic Collection CLFD24WCCSS Manuel Du Propriétaire

You can solve many common appliance problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.

Troubleshooting guide

Problem
Appliance does not operate.
Appliance is not cold enough.
Turns on and off frequently.
The light does not work.
Vibrations.
The appliance seems to make too
much noise.
The door will not close properly.

Problems with your appliance?

Possible cause
Not plugged in.
The appliance is turned off.
Tripped circuit breaker or blown fuse.
Check the temperature control setting.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The room temperature is higher than normal.
A large amount of contents has been added to
the appliance.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Not plugged in.
Tripped circuit breaker or blown fuse.
The bulb has burned out.
The light button is OFF.
Check to be sure the appliance is level.
The rattling noise may come from the flow of
the refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in
your appliance.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The appliance is not level.
The appliance is not level.
The door was reversed and not properly
re-installed.
The gasket is dirty.
The shelves are out of position.
17