Functions - Summit Classic Collection CLFD24WCCSS Manuel Du Propriétaire

Functions

 Temperature Memory Function
If the power is suddenly lost, the set
temperature will be saved by the unit. Once
the power is back on, the unit will be at the
same set temperature.
 "Close Door" Reminder Function
When you forget to close the door or the
door is not fully closed, there will be warning
alarm after 5 minutes.
 Temperature Alarm Function
If the interior temperature is higher than
73°F (23°C), "HI" is shown on the display
panel and the buzzer alarm sounds
continuously after one hour. This indicates
that the inner temperature is too high, and
you should look for the reason. If the inner
temperature is lower than 32°F (0°C), "LO"
is shown on the display panel; the alarm
and the malfunction indicator light go on at
the same time.
Note:
If too many bottles are put in at once or the
door has not been closed tightly, the unit
will display the "HI" signal on the display
panel. This is normal. Please wait 5 minutes
after closing the door and "HI" will
disappear.
Operation
 It is normal that the cabinet shows "HI" or
"LO" from time to time. If it occurs frequently
or lasts for a long time, you can restart the
unit by unplugging it, then re-plugging after
5 minutes. If the problem occurs again after
restarting, please contact customer service.
 Before reconnecting the power, wait 3 to 5
minutes. Otherwise you could damage your
appliance. If you attempt to start the
appliance before the end of this time delay,
the appliance will not turn on.
 If you turn on the appliance for the first time
or after a restart, or after it has been out of
operation for a long time, there may be a
temperature difference between the
temperature inside the appliance and that
on the LED display. This is a normal event
caused by the duration of the activation
period. Leave the appliance turned on for
several hours and the temperatures will
stabilize during operation.
11