Shelves - Summit Classic Collection CLFD24WCCSS Manuel Du Propriétaire

(Models：CLFD24WC, CL15WC , CL151WBV)
Do not cover racks with aluminum
foil or any other material that will
prevent adequate air circulation
within the cabinet.
■
To prevent damaging the doors or gasket
seals, open the doors wide when removing
the shelves.
 For easier handling of bottles, it is
necessary to pull the shelf out by at least
1/3. The sides of the shelves are equipped
with protective stoppers which prevent
bottles from falling from the shelves.
■
When removing / inserting the shelves from
/ into the rails, lift one side of the shelf as
shown in the picture below and pull the
shelf out towards you, or push it in when
inserting it, until one side is securely seated
on the rail.

Shelves

(Model：CL24WC2)
 To prevent damaging the door gasket, make
sure to have the door all the way opened
when pulling shelves out of the rail
compartment. For easy access to the
bottles, you must pull the shelves
approximately 1/3 out of the rail
compartment.
 To remove the shelves out of the rail, pull
each shelf approximately 1/3 out. Use a
long flat screwdriver to press down the left
plastic notch as shown in Figure A and at
the same time lift the right plastic notch as
shown in Figure B. Then proceed to pull out
the shelf slowly.
12
Figure A
Figure B