Operating conditions
Proper operation of the appliance is
guaranteed only if the following conditions are
met:
The temperature in the room where the
appliance is located conforms to the
climate class stated on the appliance's
rating label.
Maximum ambient relative humidity:
RH75%.
The appliance must be placed at a
sufficient distance from heat sources ( e.g.,
ovens, central heating, direct sunlight,
etc.).
The appliance must be located in such a
place that it is protected against the effects
of weather.
Regular maintenance is performed
according to the instructions in this user's
manual.
The ventilation openings on the appliance
must not be covered.
Correct installation ( e.g. leveling, the
capacity of the system corresponds to
the specifications on the rating label of
the appliance).
For Models CLFD24WC, CL242WBV and
CL15WC, CL151WBV
Control elements
1) "
" button
To turn the unit ON and OFF, press and
hold this button for approximately 3 seconds.
2) "
" button
Energy conservation button: Pressing this
button for 3 seconds will turn the energy
Operation
conservation mode ON or OFF. In this
mode, the LED light and display will turn
off, and the C/F light will be on.
3) "
Shows that the compressor is in operation.
4)
C/F" indicator light
"
The temperature scale is changed by
pressing the "C/F" button.
5) "
" button
Used to increase (warm) the temperature
in steps of 1F (or 1C).
6) "
" button
Used to decrease (cool) the temperature in
steps of 1F (or 1C).
7) "°C/°F" button
Press this button to switch the indicator
light betweenC/F.
8)
"
"
Turns the interior light ON and OFF. (If you
use this button, the light is no longer con-
trolled by the reed switch, and remains
ON.)
9) LED display
Shows the temperature of the internal
cabinet.
Setting the temperature
Insert the power plug into a properly
grounded power socket.
Use the
temperature of the appliance. Each time
the
temperature will increase / decrease by
1F (or 1C).
You can set the temperature in the range
of 39°F to 64°F (or 4°C to 18°C) .
9
" indicator light
button
buttons to set the desired
/
buttons are pressed, the
/