Installing The Handle - Summit Classic Collection CLFD24WCCSS Manuel Du Propriétaire

INSTALLING THE HANDLE

To install the handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as
shown below in Fig .1 . The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver
until the handle sets both flush and secured tightly against the door frame. DO NOT over
tighten as this will cause damage to the handle assembly. Fig .2 Replace the door gasket to its
original position.
Fig. #1
 Gasket

Phillips Head Screw
Operation
 Phillips Head Screw Driver
 Handle
14
Fig. #2