Publicité
Les langues disponibles
Les langues disponibles
4. Overrail Bedliner Installation Steps
Page 3 of 9
STEP 1
With the Bedliner Out of Truck:
Assemble "Liner-Lok™" fasteners by sliding metal clip
1.
onto plastic swingnut (see FIGURE 1).
2.
Insert screw through hole provided in bedliner side wall,
with head of screw toward inside of truck bed.
Position "Liner-Lok™" fastener with side "A" towards
3.
screw tip (see FIGURE 2).
4.
Insert screw tip into hole and metal clip of fastener and
turn one or two rotations, or until tip of screw in engaged
into fastener.
Repeat "Liner-Lok™" fastener assembly to remaining
5.
holes.
IMPORTANT: The "Liner-Lok™" must be in a loose
downwardhanging position at this time. (see FIGURE 5)
STEP 2
Repeat "Liner-Lok™" fastener assembly to remaining
holes. STEP 2 Place bedliner with loosely hanging "Liner-
Lok™" fasteners into truckbox. Pull the bedliner rails away
from truck rails and push downward starting at front
corner, until forward "Liner-Loks™" slip under the truck
rails. Make certain that all "Liner-Lok™" fasteners have
slipped under the truck rails before tightening (see
FIGURES 3, 4 & 5).
STEP 3
Close tailgate. Adjust bedliner if needed.
STEP 4
Standing or kneeling on bedliner in truck box:
1.
Start at either front (cab end) corner and push downward
on bedliner rail while turning screw clockwise with screw
driver (see FIGURE 6). You should "feel" the "Liner-
Lok™" pivot upwards and stop. Continue turning the
screw clockwise until tight (see FIGURE 7).
2.
Move to opposite corner and repeat step 4 - 1.
3.
Repeat step 4 - 1 to remaining "Liner-Loks™".
www.TrailFX.com
Rev 062816
Publicité
