Trailfx 12014X Instructions D'installation page 2

2B. Toyota Tailgate Cover Installation Steps (without rails)
3. Under Rail Bedliner Installation Steps
Page 2 of 9
STEP 1
Remove the 8 factory installed screws from the truck tailgate
(marked "X" in FIGURE 1, Section 2). Save for reinstallation.
STEP 2
Center the tailgate cover (FIGURE 1) on truck tailgate. Tip
tailgate cover on angle and slip upper edge under truck
tailgate rail cover.
Line up pre-drilled holes in tailgate cover with the 8 holes in
the truck tailgate.
STEP 3
Using screws previously removed, fasten tailgate cover to
truck tailgate using a T30 Torx Driver.
(NOTE: Some bedliners may not have front rail lip.)
CAUTION: It is recommended that two (2) people install the
bedliner to avoid damage to the painted surface of the truck.
STEP 1 (FIGURE 1)
Place bedliner in the truck bed, such that the front rail retainer fits
over the front rail of the truck bed. While standing on the side of the
truck, lift one side of the bedliner and slip the sidewall of the
bedliner under the opposite wall of truck box.
STEP 2 (FIGURE 2)
While standing at the rear of the truck, lift the bedliner floor in the
center. (FIGURE 2) This procedure allows the bedliner sidewall to
rotate away from the bed rail. Have a 2nd person slip/lock the
bedliner sidewall in position by applying a downward force. NOTE:
Make sure that the raised liner locking tabs on the sidewalls are
secured behind and under the side rail sheet metal of the truck box.
(NOTE The bedliner has been designed to allow for expansion/
contraction in extreme ambient temperatures. Therefore it is
impossible to have a perfect fit at all times.)
STEP 3
Check the overall fit. It is important that the bedliner fits securely in
place under the bed rails. If necessary, repeat steps 2 & 3.
www.TrailFX.com
Rev 062816