V-ZUG Cooler V200 Notice D'installation page 58

Installing the appliance in the recess
Fig. 34
u For unit walls which are 16 mm thick: Clip a spacer on
all hinges. No spacer is required if unit walls are 19 mm
thick.
Fig. 35
u Use a screwdriver to loosen the cover at the top left and
remove it.
Fig. 36
u Loosely screw on the mounting bracket. The bracket
should still be able to move slightly.
Fig. 37
58
Fig. 38
u Insert the appliance all the way into the unit recess. The
adjustable feet must rest in the recesses in the brackets
on both sides.
Fig. 39
u Remove the floor mounting bracket stopper. Loosen the
stopper by moving it and, if necessary, pull it off using
pliers.
Fig. 40
u Check that the appliance is flush in the cabinet recess.
The mounting bracket must be attached to the side wall
of the cabinet recess.
Fig. 41
* Depending on model and options