Wiha 45222 Mode D'emploi page 17

INSTRUCTION MANUAL
Safety
The continuity tester 45222 has been constructed and verified in compliance
with the latest safety standards for Test Instruments IEC/EN 61010-1 and IEC/
EN 61010-031 and have left the factory in safe and perfect conditions.
In order to avoid electrical shock, the valid safety and VDE regulations regarding
excessive contact voltages must receive utmost attention, when working with
voltages exceeding 120 V (60 V) DC or 50 V (25 V) rms AC. The values in
brackets are valid for limited ranges (as for example medicine and agriculture).
Prior to usage ensure perfect instrument function. The device may only be used in
specified measuring ranges.
If the operator's safety is no longer ensured, the instrument is to be put out of service
and protected against use.
The safety can no longer be insured if the instrument
• shows obvious damage.
• does not carry out the desired measurements.
• has been stored for too long under unfavourable conditions.
• has been subjected to mechanical stress during transport.
The UUT must be voltage-free. Verify this condition, if unsure, by using a voltage
tester equipped with a display.
16