Brother HL-2460 Série Guide De L'utilisateur page 17

If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the coloured insulation
of the wires inside.
Cut each of the three wires to the appropriate length. If the construction of the plug permits,
leave the green and yellow wire longer than the others so that, in the event that the cord is
pulled out of the plug, the green and yellow wire will be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the terminal in the plug
which is marked with the letter "E" or by the safety earth symbol , or coloured green or
green and yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the
letter "N" or coloured black or blue.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter "L" or coloured red or brown.
The outer sheath of the cord must be secured inside the plug. The coloured wires should not
hang out of the plug.
xvi