Remote Control - Bestway 58517 Notice D'utilisation

J Speed Setting Display
One speed bar represents one speed setting, which is represented from left to right with green representing slower speeds and red
representing faster speeds. The default speed when the machine is activated is set at 4 speed bars.

Remote control:

A Indicator light
Flashes a red color when a button is pressed
B Speed Adjustment Buttons
Press to increase or decrease the speed setting
C Emergency stop button
In an emergency, press the emergency stop switch to completely cut off the power to
the device.
D Start/pause button
Press to start or pause
If the remote control or the body of the Swimfinity is replaced,they must be paired again using the following instructions:
1. Ensure the body of the Swimfinity is in standby mode.
2. The remote control must be within 3 m (10 ft.) from the control panel.
3. On the remote control, press the speed adjustment buttons
Hold it until you hear the buzzer sound. This means the pairing was successful.
Important: after the paring operation is finished, the
button on the control panel to reset the alarm, and you may use your Swimfinity.
MAINTENANCE
Please disassemble and store the product indoors when the device will not be used for a
long period of time.
1. Turn off the transformer and unplug the power cable from the electrical outlet.
2. Disconnect the machine power cable from the transformer.
3. Remove the machine from the pool , and air-dry thoroughly .
4. Store the machine and transformer in a dry place. The storage's temperature should be
between 4°C and 40°C.
and emergency stop button
alarm will appear on the control panel. This is normal. Press the stop
4
A
B
at the same time.
D
C