CLAS HU 1106 Manuel D'utilisation page 8

HU 1106
CHARACTERISTICS
Supply tank capacity: chamber air 10L
Supply tank capacity: brake uid 5L
Max. pressure air tank: 6bar
Max. pressure brake uid supply tank: 2,5bar
Elastic rubber internal separator membrane
A : 620mm
B : 310mm
C : 240mm
Machines must be transported complete with their packaging to the
area in which they are to be installed.
All lifting and movement of machines or parts transported separately
must be performed by trained personnel.
PRECAUTIONS TO BE TAKEN DURING TRANSPORT AND INSTALLATION
Before being delivered to the ship-ping agent, the material is carefully checked.
Upon receiving the machines check that they have not been damaged during transport or that the packaging has
not been tampered with conse-quent removal of parts from inside.
In the event of damage or missing parts, inform the carrier and manufacturer immediately, producing photographic
proof.
N.B. It is advisable to check that the supply corresponds to the order speci cations.
1 • Open the ball cock (4) and (2), lift and turn the reducer knob (3) anti-
clockwise, then completely release the two tank hemispheres of all pressure by
pressing the bleed valve on the tting (5A).
2 • Unscrew and remove the ller cap (1), ll the supply tank with at most 5 litres
of uid, and close and screw down well. Close the cock (4). Never try to lower
the membrane (11) by pressing with pointed objects (Fig. 3a).
PNEUMATIC BRAKE AND CLUTCH BLEEDER
USE